Cal. No. W770
Refine your searchW770
Others
Cannot make the smartphone emit sound.
You need to fulfill the following condition to make the smartphone emit sound:
- The watch has already been paired (registered) to the smartphone.
- The registration information of the smartphone to connect with is chosen.
- The smartphone is in connectable status (actual connection is not required).
- Headphones are not connected to the smartphone.
1. Check the power reserve of the watch.
!
Charge the watch until level 2 when the power reserve level is "1" or lower.
!
You cannot connect the watch with the smartphone when the power reserve level of the watch is "0".
- Pull the crown out to position 1.
- Rotate the crown to change the mode to [TME].
- Push the crown in to position 0.
- Press the lower right button A repeatedly to make the function hand indicate power reserve.
The second hand points to 30 seconds and stops.
2 Switch registration information and make the smartphone emit sound.
- Press and release both the lower right button A and upper right button B simultaneously.
- Pull the crown out to position 2.
- Rotate the crown to choose another registration information.
- Push the crown in to position 0.
- Repeat steps 5 - 8.
!
Check whether the smartphone emits sound.
The second hand points the saving destination of registration information currently chosen and the function hand indicates connection status (ON/OFF).
!
Each time you rotate the crown, the second hand moves as follows:
"1 o'clock" → "2 o'clock" → "3 o'clock" → (back to the top)
3. When the smartphone emits no sound even after switching registration information
Below are possible causes.
- The smartphone is turned off.
- The smartphone is not in connectable area or any obstacle interferes connection.
- Headphones are connected to the smartphone.
Related articles